Filter
Top Products
- 24 BIT DIGITAL EFFECTS
RIGHT
MAIN MIX OUTPUT
LEFT
2-TRACK IN/OUT
TAPE IN
TAPE OUT
L
R
23
24
19
20
21 22
19
- PRESETS
Adjust this knob to select the right effect you wish
to perform. There are total 16 options for you:
Vibraflange, Funky, Rockabilly, Bigstage, Vibrato,
Flanger and Chorus etc.
21
- REVERB LEVEL control
This control is used to adjust the output level of REVERB signal, which can be varied from 0dB to 10dB.
22
- PEAK LED
This LED lights up when the input signal is too
strong.
- FX LEVEL control
This control is used to adjust the output level of FX
signal, which can be varied from 0dB to 10dB.
20
- MAIN MIX OUTPUT
This stereo output is controlled by the MAIN MIX
LEVEL and will send the audio signal to an external
amplifier. The output level can be varied from -
to +1 dB
23
- 2-TRACK IN/OUT
TAPE IN
Use the Tape input if you wish to listen to your
mixer from a Taper Recorder or DAT.
You can send the signal coming form the Taper
Recorder(or DAT) either to CONTROL ROOM
OUTPUT and/or to the MAIN MIX OUTPUT by
using relative 2TK TO select button.
24
TAPE OUT
These RCA jacks will route the main mix signal into a tape recorder.
25
PRESETS
10
8
9
1
12
11
7
4
5
6
3
2
13
14
15
16
0
5
16
13
12
9
8
4 BIGSTAGE
3 ROCKABILLY
2 FUNKY
1 VIBRAFLANGE
FX LEVEL REVERB LEVEL
100
VIBRATO
FLANGER
CHORUS
PEAK
10
10
25
PHANTOM PWR
26
277
26
- PHANTOM PWR
This switch is used to apply +18 Volt Phantom Power only to the 2 XLR inputs sockets. When these sockets are
connected with devices that do not require Phantom Power,
Please make sure the Phantom Power is turned off,
otherwise, this may damage the device and mixer.
27
- POWER AMP
This control is used to turn ON or OFF the built-in power amplifier.
POWER AMP
onoff