Filter
Top Products
This rotary knob is used to control the master output level (volume).
To avoid distorted output try to maintain an average output signal level +4 dB. Be sure this volume
control is always set to zero before turning the unit on.
This knob selects the channel for monitoring. The monitor signal comes
from the Prefader. This means it will not be affected by the channel faders. You can monitor each chan-
nel individually. Connect your headphones to the . Turn the CUE MIXING
CONTROL to CUE and select the desired channels with the PFL switches. When you turn the CUE
MIXING CONTROL to PGM (PFL switches without function), you can cue the output signal of the mixer.
If the CUE MIXING CONTROL is set to the center position, you can cue both the channel signal you
selected and the output signal.With the CUE LEVEL control, you can adjust the phones volume without
changing the output signal.
This knob is used to adjusts the headphone volume output
level. Turn the knob in a clockwise direction to increase the headphone volume.
This button activates the MIDI function.
This button is used to change the operating mode of the
. When the switch is in the Master L/R position, the meter will indicate the
master output levels. When the switch is in the PFL CH1/CH2 position the meter will use the left side
of the meter to indicate channel one’s prefader level and use the right side of the meterto indicate
channel two’s prefader level.
©American Audio® - www.AmericanAudio.us - DV2 USB Instruction Manual Page 5
Top Panel
1
17161514
4
3
2
6
5
9
12
11
10
13
7
8