Filter
Top Products
(1) POWER SWITCH - Red LED will light when power is ON.
(2) LOW / MID / HI CONTROL - Used to increase or decrease the LOWs (bass), MIDs and HIs (treble) of the input
signal for each channel. The XDM-3633 features “Rotary Kills” with -30dB to +20dB output control.
(3) PHONO / AUX / LINE SWITCH - Used to select the input to be sent to the individual channel. Channels 1 and 2 may
be switched PHONO/AUX or LINE, Channel 3 may be switched PHONO/AUX, LINE 3 or LINE 4, and Channel 4 may be
switched LINE 5, LINE 6 or MIC 3. The selectors for AUX1/PHONO1, AUX2/PHONO2 and AUX3/PHONO3 are on the
rear panel (41). MIC 3 1/4” stereo input is also on the rear panel of the mixer (36).
(4) GAIN CONTROL - Used to set the level of the input signal for its designated channel.
(5) PFL / CUE BUTTONS - Use the PFL button to engage the input level of each channel. Channels 1 - 4 have PFL
buttons.
(6) PFL DISPLAY - When PFL button is on, LEDs show the level of the channel currently being cued. Each channel has
its own PFL LED display.
(7) LOW CUT BUTTON - Cut -30dB for bass.
(8) EFFECTS BUTTON - Individual send and receive for CHANNELS 1 - 4, MIC 1 & MIC 2. Selects effect loop In or
Out. 1/4” (6.3mm) connection is on the rear panel (46).
(9) MIC 1 & MIC 2 JACKS - Designed with Neutrik™ connection - connect microphones with 1/4” (6.3mm) jack plug or
XLR plug.
(10) MIC EQ - Use these controls to fine tune the signal for MIC 1 & MIC 2. Increase the LOWs, MIDs & HIs by turning
the respective control to the right. MIC 3 EQ may be adjusted by the Channel 4 LOW / MID / HI CONTROL (2).
(11) AUTO MUTE / TALKOVER SWITCH - Use this switch when using the microphone. MIC 1 & MIC 2 feature AUTO
MUTE. When AUTO MUTE switch is activated and the DJ begins speaking into the microphone, all other channels will
mute (turn off). As soon as the DJ stops speaking, all channels will be restored to their original levels. MIC 1 also fea-
tures a function called TALKOVER. If the switch on MIC 1 is set to TALKOVER, all signals but the microphone level are
attenuated (or drop) by -15dB when the microphone is voice-activated. As soon as the DJ starts speaking, the output
level is reduced. As soon as the DJ stops speaking, the output level is reset to the original level. After speaking, the
switch should be manually set back to the OFF position.
XDM-3633 User Instructions page 5
Functions (Front Panel)
1
2
4
14
3
15
17
16
11
21
22
34
29
12
1518
5
10
20
13
26
30
9
19
6
7
8
33
32 31 28
27
25
24
23