Filter
Top Products
The insert is a break point in the input channel signal path, It allows the signal to be taken out from this ,
through an external equipment (such as a Limiter, Compressor, Equalizer, Effector) and then back to the ,
the input jack can be used with TRS phone jack, the signal will be sen out through the TIP of the TRS
phone jack and back to the through the RING of the TRS phone jack.
AKJ780D
AKJ780D
AKJ780D
¼-inch t ¼-inch
¼-inch
4. :Connecting Effects Using the EFFECT INSERT
1.
2.
3.By using the built-in EFFECT INSERT you can add external effects to vocals and/or guitar or keyboard or
microphone without compromising the quality of the original signal.
Connect one end of the ¼-inch stereo audio cables to the GUITAR EFFECT, KEYBOARD EFFECT, or
MIC EFFECT inserts on the rear panel of the AKJ780D.
Connect the other end of the ¼-inch stereo audio cables to the sound effect device.
Basic Connections
DVD Output Connections
DVD Output Connections
1.Connecting to a Dolby Pro Logic Amplifier
The allows DVD audio output for 5.1 or 7.1 configurations.
With a 5.1 amplifier, you will need six RCA patch cables. Connect the plug from one side of each cable to the
ML, CEN, SL, MR, SW and SR outputs on the . Connect the plug from the other side of each cable to
the corresponding ML, CEN, SL, MR, SW and SR inputs on your 5.1 amplifier.
A 7.1 Pro Logic configuration requires 2 additional RCA cables to be connected from the FL and FR outputs of
the to your 7.1 Amplifier.
sAKJ780D
AKJ780D
AKJ780D