Filter
Top Products
AT W-R1810 Single-channel Receiver Controls (front panel)
Liquid Crystal Display shows battery status and frequency settings.
BNC-type antenna connectors. Attach the antennas to the antenna input jacks. Make certain
that during operation there is a clear open-air path between the receiver antennas and the
transmitters.
True Diversity operation: two antennas feed two completely independent RF sections on the
same frequency; automatic logic circuitry selects the superior signal.
Diversity Indicators A and B show which tuner has the better reception and is in operation.
Turns the unit on and off. Use with the Up/Down arrows to choose operating frequencies
manually or automatically (using your choice of three automatic scan groups).
Indicates when the unit is on. Also indicates receiver overload by turning off; too much signal
will cause blinking LED (off during peaks). To correct overload, adjust audio gain on transmitter.
(See Audio Input Level (Gain) Adjustments on your transmitter, page 12.)
Press Up or Down arrows, in conjunction with the Power/Set button, to choose operating
frequencies manually or automatically (using your choice of three automatic scan groups).
LCD
Antenna Input Jacks
Diversity Indicators
Power / Set Button
Power/Peak LED
Up/Down Arrows
1
2
3
4
5
6
2
3
6
1
2
5
4
6