Filter
Top Products
Ten Tips To Obtain The Best Results
1. Use only fresh alkaline batteries; replace the receiver
batteries in pairs. Do not use “general purpose” (carbon-
zinc) batteries.
2. Position the receiver so that it has the fewest possible
obstructions between it and the normal location of the
transmitter. Line-of-sight is best.
3. The transmitter and the receiver should be as close
together as conveniently possible, but no closer together
than three feet.
4. The receiver antennas should be in the open and away
from any metal.
5. The transmitter and receiver must be set to the same
channel number. (Use “x” units together and non-”x”
units together.)
6. Only one transmitter on a given frequency should be
“on” at a time.
7. The power switch on the transmitter has three
positions: “Off,” “Standby,” and “On.” In the middle
“Standby” position, the transmitter sends only RF to
the receiver; the audio source is turned off.
8. If the “Out Level” of the receiver is set too high, it
may over-drive the input of the camera/mixer or clip
the output of the receiver, causing distortion.
Conversely, if the receiver output is set too low, the
overall signal-to-noise ratio of the system may be
reduced.
9. You need to change channels 1) when a strong
interference signal is received, 2) when the channel
breaks down, or 3) during multiple-system operation in
order to select an interference-free channel. Always
turn the units off before changing frequencies.
10. Turn the receiver and transmitter off when not in use.
Remove the batteries during long-term storage.
One-Year Limited Warranty
Audio-Technica professional wireless systems purchased in the U.S.A. are warranted for one year from date of purchase by
Audio-Technica U.S., Inc. (A.T.U.S.) to be free of defects in materials and workmanship. In event of such defect, product will be
repaired promptly without charge or, at our option, replaced with a new product of equal or superior value if delivered to A.T.U. S .
or an Authorized Service Center, prepaid, together with the sales slip or other proof of purchase date.
Prior approval from
A.T.U.S. is required for return.
This warranty excludes defects due to normal wear, abuse, shipping damage, or failure to use
product in accordance with the instructions. This warranty is void in the event of unauthorized repair or modification, or removal
or defacing of the product labeling.
For return approval and shipping information,
contact the Service Dept., Audio-Technica U.S., Inc., 1221 Commerce Drive,
Stow, Ohio 44224.
Except to the extent precluded by applicable state law,
A.T.U.S. will have no liability for any consequential, incidental, or
special damages; any warranty of merchantability or fitness for particular purpose expires when this warranty expires.
This warranty gives you specific legal rights, and you may have other rights which vary from state to state.
Outside the U.S.A., please contact your local dealer for warranty details.
11