Califone PA916-SD DJ Equipment User Manual


 
19
Specifications PA916-SP
The PA916-SP is connected to one of two outputs
from the PowerPro PA916 or Powered Companion
Speaker via SP-50 Cable with 1/4” phone plugs.
Connecting to the “Speaker Out” jack will divide
the power between the PowerPro PA916 or
PA916-PS and PA916-SP. Connecting to the
“Switched Out” will disconnect the internal
speakers of the PA916 and deliver all of the power
to the PA916-SP.
NOTE:
There are ve (5) LEDs on the front of the
speaker, however they are disconnected because
there is no internal amplier or wireless
receiver in this passive system.
Telescoping Handle
1/4” Phone Jack Speaker In
Integral Wheels
1
2
3
1
2
3
Mechanical Notations
Telescoping Handle and Wheels
These are only intended for pulling the PowerPro over relatively smooth surfaces. Using the handle to lift or
carry the unit or pulling up stairs will cause damage not covered by the warranty.
Tripod Mount
A recess is incorporated on the bottom of all PowerPro Speakers for mounting to the TP-50 tripod.
califone_916SD_manual_rev3.indd 22 6/23/07 4:00:40 PM