Filter
Top Products
3
Operation
Battery
Charge the battery for at least 10 hours before using the PA916 or PA916-PS. Simply plug the power cord into an AC
outlet and charging begins automatically. The charging indicator will ash until fully charged, then it will stay green. The
unit can be used while it is plugged in for charging.
There are two indicators above the main power switch. When the unit is turned on, the one on the left will light “red”
when the battery has a low charge. The one on the right will glow “green” if the battery is fully charged or if operating
on A/C power.
It is recommended that the battery be recharged after several hours of usage, rather than stored with a low battery. This
will prolong battery life. Storing more than 30 days without recharging will deteriorate the battery.
Digital Master Volume Control
When the main power switch is turned on, the Digital Master Volume Control is at the lowest level to prevent accidental
damage to the amplier or internal speakers. The volume can be controlled in two ways; using the “Up” “Down” buttons
on the mixer panel or using the RC-300 infrared remote control. The remote sensor must be used in front of the speaker
as the sensor is behind the speaker grille.
Recommended Set-up Procedure
Ideally the master volume should be at maximum volume before the wireless receiver and microphone volumes
are adjusted to the desired loudness. Since there are always at least two (2) volume controls to contend with, it is
suggested that prior to turning the power on the UHF receiver volume controls be set at “10 o’clock”. Also set the
microphone volume controls at “10 o’clock”. Turn on the main power switch and use either a wireless microphone
or cabled microphone to adjust the master volume.
Digital Audio Player/Recorder & CD Player
The main power switch does not control the Digital Audio Player/Recorder and CD player. A separate power switch is
combined with the MP3/CD volume control to limit battery drain when the Digital Audio Player/Recorder or CD are not
being used.
Wireless Receivers
There are two (2) independent combination XLR/1/4” jacks for using microphones with cables. Each jack has a volume
control which eects the loudness of both wired and wireless microphones. Also each has a “Voice/Music” switch. On
“music” program the sound is full delity, while on “voice” the sound is tailored to give maximum projection while limit-
ing battery drain.
califone_916SD_manual_rev3.indd 6 6/23/07 4:00:29 PM