Filter
Top Products
E-44
Overdubbing a Performance
Recording
You can use the following procedure to record a melody in
Track 2 so it combines with a recording you previously made
in Track 1.
1
Press the RHYTHM button to enter the rhythm
mode.
2
Use the RECORDER button to select record standby.
3
Press the RIGHT/TRACK 2 button to select Track 2
as the recording track.
4
Select the tone you want to use.
5
Press the controller block START/STOP button.
• This starts playback of Track 1 and recording in
Track 2.
6
Play the melody notes you want as you listen to
the playback from Track 1.
7
To stop recording, press the controller block START/
STOP button again.
• If you make a mistake, you need to go back and re-
record from step 2.
• If you want to immediately hear what you recorded,
press the controller block START/STOP button again.
NOTE
• Track 2 is a melody-only track, which means that chord
accompaniment cannot be recorded there. Because of
this, the entire range of the keyboard becomes a melody
keyboard when recording the Track 2, regardless of the
current MODE switch setting.
• If you want to record without playback from a recorded
track, enter playback standby, deselect the playback
track, and then enter record standby. Note, however,
that you cannot turn off rhythm and Auto
Accompaniment.
Recording and Play Back
Flashing
Indicator
appears
Track 2 Data
In addition to notes played on the keyboard, the following
data is also recorded to Track 2.
• Tone number
• Pedal operations
Deleting a Specific Part/Track
You can use the following procedure to delete a specific
part/track from a lesson recording or performance recording.
Getting Ready
■When deleting a lesson recording part
• Press the SONG BANK button.
■When deleting a performance recording track
• Press the RHYTHM button.
1
Press the RECORDER button to enter record
standby.
2
Select the part/track you want to delete by pressing
the LEFT/TRACK 1 button or RIGHT/TRACK 2
button.
3
Hold down the RECORDER button.
• This causes a confirmation message to appear on the
display.
• To cancel the delete operation, press the [–] (NO)
button .
4
Press the [+] (YES) button to delete the part/track.
• This causes the keyboard to return to playback
standby.
NOTE
• Pressing the RECORDER button while the part/track
delete screen is on the display returns to record standby.