Filter
Top Products
E-10
Playing with Different Tones
Reverb. . . .Makes your notes resonate.
Chorus . . .Adds more breadth to your notes.
To configure reverb and chorus effect
settings
1.
While holding down the TONE/SETTING
button, press the REVERB or CHORUS
keyboard key.
Example: Selecting Reverb 4
• Reverb Value
•Chorus Value
1.
Press the METRONOME button.
• This starts the metronome.
• The lamp above the X/
button flash in time with the
metronome beat.
2.
To change the beat, hold down the TONE/
SETTING button as you press one of the
METRONOME BEAT keys to select a beat
setting.
• You can specify a beat value of 0, 2, 3, 4, or 6 as the
beat. Specifying 0 as the setting plays a straight click,
without any chime. This setting lets you practice with
a steady beat.
3.
While holding down the TONE/SETTING
button, use the TEMPO keys to specify a
tempo value in the range of 20 to 255 beats
per minute.
• Each press of the + or – key raises or lowers the
tempo value by 1.
• You can use the value input keys (0 to 9) to enter a
specific value. Be sure to input all three digits.
Example: To enter “96”, press keys 0, 9, 6.
Using Effects
To do this: Select this setting:
Turn off reverb OFF
Turn on reverb
1: Room
2: Small Hall
3: Large Hall
4: Stadium
To do this: Select this setting:
Turn off chorus OFF
Turn on chorus
1: Light Chorus
2: Medium Chorus
3: Deep Chorus
4: Flanger (Whooshing effect)
Using the Metronome
PX120_e.book 10 ページ ２００７年６月２６日 火曜日 午前１１時３６分