Filter
Top Products
E-30
Reference
Troubleshooting
Problem Cause Action See Page
No sound is
produced when I
press a keyboard
key.
1. The VOLUME controller is set to
“MIN”.
2. Headphones are connected to the
digital piano.
3. MIDI Local Control is turned off.
4. Check the current accompaniment
mode setting. Normally, the
accompaniment keyboard range will
not produce any note while CASIO
CHORD or FINGERED is selected as
the Auto Accompaniment mode.
1. Rotate the VOLUME controller more
towards “MAX”.
2. Unplug the headphones from the
digital piano.
3. Turn on the Local Control setting.
4. Change the accompaniment mode to
NORMAL.
) E-7
) E-5
) E-28
) E-17
The pitch of the
digital piano is off.
1. The digital piano’s key setting is
something other than “0”.
2. Digital piano tuning is incorrect.
1. Change the key setting to “0”, or turn
digital piano power off and then back
on again.
2. Adjust digital piano tuning, or turn the
digital piano off and then back on
again.
) E-27
) E-27
No sound is
produced when I try
to play back a built-in
song or a recorded
song.
1. The VOLUME controller is set to
“MIN”.
2. Headphones are connected to the
digital piano.
1. Rotate the VOLUME controller more
towards “MAX”.
2. Unplug the headphones from the
digital piano.
) E-7
) E-5
When I play
something on the
digital piano, my
connected external
MIDI sound source
does not sound.
1. The digital piano’s send channel is
different from the send channel of the
external MIDI sound source.
2. The volume or expression setting of
the external sound source is “0”.
1. Change the send channel settings of
the digital piano and/or the external
MIDI sound source so they are the
same.
2. Adjust the volume and expression
settings of the external sound source.
) E-28
) External
sound
source
user’s guide
A tone’s quality and
volume sounds
slightly different
depending where it is
played on the
keyboard.
This is an unavoidable result of the digital sampling process,* and does not indicate malfunction.
* Multiple digital samples are taken for the low range, middle range, and high range of the original
musical instrument. Because of this, there may be a very slight difference in tonal quality and
volume between sample ranges.
When I press a
button, the note that
is sounding cuts out
momentarily or there
is a slight change in
how effects are
applied.
This happens when the sounds of multiple parts are sounding at the same time while using layer,
using the Duet Mode, playing back a built-in tune, recording, etc. Pressing a button when one of these
conditions exists will cause the effect setting that is built into the tone to change automatically, which
causes the notes to cut out momentarily or causes a slight change in how effects are being applied.
PX120_03_e.fm 30 ページ ２００７年７月２日 月曜日 午前１０時３４分