Filter
Top Products
Assembling the Stand
E-25
PREPARATION
• Before starting assembly of the stand, divide the
polystyrene foam packing material
K
into the sections as
shown in the illustration below. After dividing up the
material, you should end up with a total of six pieces
named
K
-(
a
)
,
K
-(
b
)
, and
K
-(
c
)
, which you will use while
assembling the stand.
• If you do not have any packing material available for
some reason, use a magazine or some other thick item.
1.
Place the digital piano onto the two K
-(
a
)
foam pieces.
* Make sure that the edges of the brackets on either
side of the digital piano are positioned at the top of
the foam pieces.
2.
Perform the following steps to attach side
panel A to the digital piano.
IMPORTANT!
• When inserting the corner of the side panel into the
bracket on the side of the digital piano in step (2-3)
below, take care to avoid damaging the side panel corner
(
). Never try to insert the side panel into the bracket
without first tilting the side panel at an angle as instructed
in step (2-2). Doing so creates the risk of damage of the
side panel corner.
(2-1) On side panel
A
, locate the corner that has a metal
piece attached to it, and then insert that corner
into foam piece
K
-(
b
)
.
(2-2) Tilt side panel
A
slightly as indicated by the
arrow in the illustration.
(2-3) Keeping side panel
A
tilted at an angle, carefully
insert the opposite corner (
) into the bracket on
the side of the digital piano.
3.
Keeping side panel A tilted at an angle, align
the side panel with side of the digital piano.
(3-1) Push side panel
A
in the direction indicated by
the black arrow in the illustration to align the side
panel so there is as little space as possible between
its top edge
A
and the bottom of the top panel of
the digital piano (
).
(3-2) After alignment is complete, stand side panel
A
straight up so it is firmly against the side of the
digital piano.
IMPORTANT!
• When performing step (3-1) above, make sure that you
position side panel
A
so its top edge reaches the bottom
of the digital piano top panel. If it does not, you will not be
able to stand side panel
A
straight up in step (3-2).
K
-(c)
K
-(a)
K
-(b)
K
-(a)
K
-(a)
Bracket
*
Bottom of the digital piano
K
-(b)
A
(2-1)
(2-2)
(2-3)
Bracket
(3-2)
(3-1)
K
-(b)
A
Top panel of the digital piano
B
PX720_03_e.fm 25 ページ ２００７年８月１０日 金曜日 午後２時２４分