Filter
Top Products
Assembling the Stand
E-27
10.
Remove the screws that hold the corner
brackets in place on the back corners (the
corners away from the pianist) of the side
panels.
11.
As shown in the illustration, reverse the
corner brackets you removed in step 10, and
insert pedal unit brackets
I
-(a)
and
I
-(b)
between the each of the corner brackets and
the side panels
A
and
B
.
WARNING
• The corner brackets help to prevent the stand from
tipping over. Whenever the stand is in a location that is
not up against a wall, reorient the corner brackets as
shown in the illustration. Leaving the corner brackets in
their original orientations can make it easy for the stand
to tip over towards the back, creating the risk of personal
injury.
12.
Securely tighten the screws G that you
temporarily tightened in step 9.
• Cover the screw heads with the caps
J
.
13.
Secure the corner brackets to the stand using
the screws you removed in step 10.
IMPORTANT!
• Press down on the edges of the pedal unit as you tighten
the corner bracket screws.
• The side panels have joint connectors inside that engage
with the corner bracket screws. If you have trouble
inserting the screws into the joint connector screw holes,
use a screwdriver to rotate the joint connector and adjust
the position of the screw hole for easier access. See the
detail drawing (marked with a star) in the above
illustration.
B
A
I
-(b)
I
-(a)
G
J
B
PX720_03_e.fm 27 ページ ２００７年８月１０日 金曜日 午後２時２４分