Cubix™ User Manual (Rev. 01a) Page 9 of 18
Configuration (Standalone Modes)
Set this product in one of the standalone modes to control it without a DMX controller.
1) Connect this product to a suitable power outlet.
2) Turn this product on.
Sound Active Mode
To enable the Sound Active mode, do the following:
1) Set DIP switch [9] to the ON position.
2) Turn the music on and adjust the microphone sensitivity knob until the fixture
starts reacting to the beat of the music.
The fixture will only respond to the low frequencies of the music (bass and
drums).
Automatic Mode
Never connect a fixture that is operating in any standalone mode, whether
Static, Automatic, or Sound to a DMX string connected to a DMX controller.
This is because fixtures in standalone mode may transmit DMX signals that
could interfere with the DMX signals from the controller.
To enable the Automatic Mode, follow the instructions below:
1) Set DIP switch [8] to the ON position.
Manual Mode
See the chart below for details on manual DIP switch operation. Some DIP switches
may be combined.
Function
DIP switches
1
2
3
4
5
6
7
8
9
10
Red
X
Green
X
Blue
X
RGB Strobe (fast)
X
Center effect
X
Center strobe
(fast)
X
Motor rotation
X