Filter
Top Products
2-2
Cisco VG224 Voice Gateway Software Configuration Guide
OL-5005-01
Chapter 2 Using the setup Command
Using the setup Command
Using the setup Command
The setup command facility is displayed in your PC terminal emulation program window.
To create a basic configuration for your Cisco VG224, do the following:
• Complete the steps in “Configuring Global Parameters” section on page 2-2.
• Complete the steps in “Configuring Controller and Interface Parameters” section on page 2-5.
• Complete the steps in “Completing the Configuration” section on page 2-6.
Note If you make a mistake while using the setup command facility, you can exit and run the facility again.
Press Ctrl-C, and type setup at the enable mode prompt (Router#).
Configuring Global Parameters
Step 1 Power on the Cisco VG224. The power switch is on the rear panel of the Cisco VG224, at the lower-right
corner, near the power cord.
Messages begin to appear in your terminal emulation program window.
Caution Do not press any keys on the keyboard until the messages stop. Any keys pressed during this time are
interpreted as the first command typed when the messages stop, which might cause the Cisco VG224 to
power off and start over. It takes a few minutes for the messages to stop.
The messages look similar to the following:
Note Much of the following example is largely for a Cisco VG224. The messages vary, depending on
the Cisco
IOS software release, interface modules in place in your Cisco VG224, and feature set
you select. In addition, the word “Router” is the default prompt, and may appear elsewhere;
interpret this word as meaning “Cisco VG224.” The screen displays in this section are for
reference only and might not exactly reflect the messages on your console.
System Bootstrap, Version 12.3(20030210:192652) [INT-mcebu_sb.wk.0.3.2 102], DEVELOPMENT
SOFTWARE
Copyright (c) 1986-2003 by cisco Systems, Inc.
FPGA readonly version:0015001C
FPGA upgrade version :001A001E
Upgrade FPGA currently running
cvg224 processor with 131072 Kbytes of main memory
Main memory is configured to 64 bit mode with parity disabled
Upgrade ROMMON initialized
rommon 1 > dir slot0:
program load complete, entry point:0x80008000, size:0xa0e0
Directory of slot0:
2 9711556 -rw- vg224-i6s-mz-swell_2.0.4.1
9486 10051540 -rw- vg224-i6s-mz.pi3_dhcp
rommon 2 > b slot0:vg224-i6s-mz-swell_2.0.4.1