Filter
Top Products
4-3
Cisco VG224 Voice Gateway Software Configuration Guide
OL-5005-01
Chapter 4 Configuring Voice over IP
Where to Go Next
Step 10 The results of the show running-config and show startup-config commands differ from each other if
you have made changes to the configuration, but have not yet written them to NVRAM. To write your
changes to NVRAM, making them permanent, enter the copy
running-config startup-config command
at the enable prompt:
Router# copy running-config startup-config
Building configuration. . .
[OK]
Router#
The Cisco VG224 is now configured to boot in the new configuration.
Where to Go Next
For further information on VoIP configuration procedures and debug commands, refer to the following:
• Cisco IOS Voice Configuration Library.