Filter
Top Products
12
CSM8/12/16/24 Console Mixer
Applications: House of Worship Installation:
This setup shows one way of using the mixer and one stereo power amplifier to run both the house speakers and the stage
monitors. Two mono power amplifiers may be used in place of the one stereo amplifier.
Connect the components as follows:
(A) Connect a balanced or unbalanced signal cable between the mixer’s Left Balanced Output and the house power ampli-
fier’s Channel 1 Input. Connect the Right Balanced Output and the Channel 2 input in the same manner.
(B) Connect a speaker cable between the house power amplifier’s Channel 1 Outputs and the left house speakers’ Inputs.
Connect the Channel 2 Outputs to the right house speaker in the same manner.
(C) Connect an unbalanced signal cable between the mixer’s Aux 1 Send and the monitor power amplifier’s Input.
(D) Connect a speaker cable between the monitor power amplifier’s Outputs and the monitor speakers’ Inputs.
(E) Connect an unbalanced signal cable between the mixer’s Aux 2 Send and the radio feed for broadcasting purposes.
(Note the optional use of graphic equalizers in-line with the connections between the mixer and the power amplifiers as shown below.)
STEREO
POWER AMP
(SPA1400, etc.)
HOUSE
SPEAKERS
(PS115HD,
PS215HDT,
etc.)
DUAL
GRAPHIC EQ
(LS3231,
LS2215)
CSM8/12/16/24
CH.1
INPUT
CH.2
INPUT
CH.1
OUTPUT
CH.2
OUTPUT
CH.1
OUTPUT
CH.2
OUTPUT
CH.1
INPUT
(PAN FULL
LEFT)
(PANS AS NEEDED)
(PAN FULL
RIGHT)
(PAN FULL
LEFT)
(PAN FULL
RIGHT)
CH.2
INPUT
MONITOR
SPEAKERS
(M112HD,
M115HD, etc.)
LEFT
BAL.
OUT
RIGHT
BAL.
OUT
AUX1
SEND
AUX2
SEND
MONO
OUTPUT
MONO
POWER AMP
(SPA1400, etc.
in Bridged Mode)
GRAPHIC EQ
(LS1131,etc.)
INPUT
OUTPUT
MONO
INPUT
A
B
D
E
C
RL
PULPIT MIC, LAVALIER MIC, INSTRUMENTS,
VOCAL MICS
RADIO FEED
RL
Controlling The Mixer’s Output Levels:
• Monitors: Use the Aux 1 master slider (#30, page 6) to set the level of the output signal for the monitors.
• Mains (House Speakers): Use the Left and Right master sliders (#31, page 6) to set the levels of the output signals for the
house speakers.
• Channels: Use the channel Pan controls (#11, page 4) to determine which channel signals are sent to the left and/or right
outputs.
• Radio Feed: Use the channels’ Aux 2 controls (#9, page 4) and the master Aux 2 Send control (#24, page 6) to set the lev-
els of the signal sent to the radio feed, if broadcasting.