Filter
Top Products
PAGE 207
FIREBALL INSTALLATION & USER’S GUIDE - M22001-01A1
APPENDIX H - REMOTE CONTROL
a. Press TV once. The LED will blink twice.
b. Enter the TV code for your TV/VCR Combo. If correct, the LED will blink
twice.
If there is no separate TV code listed, you will need to perform the following steps to
access volume control:
a. Press and hold CODE SET until the LED blinks twice, then release CODE
SET.
b. Enter 9 - 9 - 3 . The LED will blink twice.
c. Press DVD once. The LED will blink twice.
Searching for Your Code
If your device does not respond to the Remote after trying all codes listed for your brand,
or if your brand is not listed at all, try searching for your code. For example, to search for
a code for your TV:
1. On the Remote, press TV once.
2. Press and hold CODE SET until the LED blinks twice, then release CODE SET .
3. Enter 9 - 9 - 1. The LED will blink twice.
4. Aim the remote control at the TV and slowly alternate between pressing PWR and
TV. Stop when the TV turns off. NOTE: In the search mode, the Remote will send IR
codes from its library to the selected device, starting with the most popular code rst.
5. Press CODE SET once to lock in the code.
6. To search for the codes of your other components, repeat steps 1 through 5, but