Escient E-40 Musical Instrument User Manual


 
PAGE 46
FIREBALL INSTALLATION & USERS GUIDE - M22001-01A1
CHAPTER 2 - SETTING UP FIREBALL
FireBall Power States: On, Standby, Off
After the FireBall unit is plugged in, the Standby LED located next to the power button
will ash until the startup process is complete. Please wait. This may take several
minutes depending on the size of your music collection.
When the Standby LED is solid ON, the FireBall is now in a standby or “sleep” mode.
There is no video output when FireBall is in standby mode and the front panel display
is off. Press the Power button (on the front panel or on the remote) once and the video
output and front panel display will turn on. The unit is now ON.
To change from the ON mode back to the standby or “sleep” mode, press the Power
button on the front panel or on the remote once.
If power is removed from FireBall for any reason, including a power outage or if the unit
is unplugged, FireBall will automatically return to the Standby state as soon as power is
restored. When FireBall is turned on again, FireBall will return to the same source mode
that it was in when power was lost.
To force the FireBall to restart, PRESS and HOLD the Power button for 4 seconds,
and release it when the standby LED starts blinking. When the Standby LED is solid
on and FireBall has completed its startup process, press the Power button once to turn on
the FireBall.
Please follow the guidelines
regarding Power ON and Power
Standby procedures.
FireBall has four power states:
1. ON - you will see video
output on your display.
2. STARTING (ashing LED)
3. STANDBY or SLEEP - no
video output, the Power
LED is lit constant, powered
but not running.
4. OFF - unplugged from the
wall.