Filter
Top Products
These LEDs are numbered 1, 2, 3 and correspond to the three
positions within each of the selection ranges A, B, C, D on
each knob. Use the LEDs to determine exactly which position
the knob is pointing to, for example, A 1 is shown below:
Effect Selections
The tables below list the effect selections for each knob.
MODULATION EFFECTS
A1 Chorus
A2 Chorus Deep
A3 Flanger
B1 Bias/Sine Tremolo
B2 Optical/Vintage Tremolo
B3 Optical/Vintage Tremolo Fast
C1 Vibratone Slow
C2 Vibratone Fast
C3 Octaver
D1 Phaser Slow Deep
D2 Phaser Medium
D3 Step Filter
DELAY EFFECTS REVERB EFFECTS
A1 Tape Delay 150ms / 1 Repeat
A2
Stereo Tape Delay 300ms / 3 Repeats
A3
Mono Delay 700ms / 4 Repeats
B1 Small Room Reverb
B2 Plate Reverb
B3 Large Hall Reverb
C1 Fender '65 Spring Reverb
C2 Fender '63 Spring Reverb
C3 Tape Delay Room
D1 Tape Delay Large Hall
D2 Ducking Delay Small Hall
D3 Echo Filter
♫
You can completely change the effects list on your
Mustang™ amplifier using Fender® FUSE™ software
available at www.fender.com/support.
Effects Level
You can adjust the effects level by holding down the EXIT
button while rotating either the MOD or DLY/REV knob,
depending on which effect type you want to adjust.
Tap Button
The TAP button can be used to "tap in" delay time and
modulation rate settings:
• Delay time — TAP button blinks green:
• Modulation rate — TAP button blinks red:
When you select a delay effect, the TAP button will blink
green in time with the delay time setting. When you select a
modulation effect, the TAP button will blink red in time with
the modulation rate setting.
When both delay and modulation effects are selected
simultaneously, the TAP button will blink green and only
control the delay time setting.
♫
You can use TAP to set both delay time and modulation
rate by tapping in the modulation rate first, with NO
delay effect selected, then adding a delay effect and
tapping in the delay time last.
To set the TAP interval of effects:
1. Select an effect that causes the TAP button to blink, using
the DLY/REV or MOD knob.
2. Press the TAP button rhythmically (twice minimum) in time
with the desired interval.
These LEDs are linked to the
knob that is being turned
9
MU STA NG
™
I / II
f e n d e r . c o m