Filter
Top Products
5. INSTALLATION
19
5.2 Mounting
5.2.1 Wind Transducer FI-5001 (for FI-501, FI-502)
Installation site
Fix the transducer to the mounting mast so that its mounting base is par-
allel with the water line. Also, position the transducer so its leading edge
faces the bow.
Mounting procedure
1. Orient the mounting base as shown in the figure below, with the
threaded part of the mounting base facing the bow. Fix the mounting
base to the mast with four self-tapping screws (supplied).
2. Pass the connector on the transducer through the hole in the mount-
ing base and then screw the cap on the transducer into the mounting
base.
BOW
Self-tapping Screw
(4x20, 4 pcs.)
(TOP VIEW)
5
50
40
±0.5
7.5
80
55
±0.5