Filter
Top Products
5. INSTALLATION
20
3. Mate the connector at the rear of the transducer to cable assy.
FI-50-SENSOR-30/50 (30 m or 50 m, supplied).
4. As shown in the figure below, make a loop in the cable assy. Fix the
cable to the mounting base with two cable ties (local supply).
5. Pass the cable assy. through the mast and connect it to the FI-501/FI-
502. If the connector of the cable cannot be passed through the mast
(because mast diameter is too small), use the terminal box (supplied)
to make the connection. For how to use the terminal box, see page
25.
Mounting
Base
Wind
Transducer
Cable Assy.
FI-50-SENSOR-30/50
Cap
Cable Tie (local supply)
Cable Assy. FI-50-SENSOR-30/50
(30 m or 50 m)