Gemini CDX-O4 Musical Instrument User Manual


 
IN THE USA: IF YOU EXPERIENCE PROBLEMS WITH THIS UNIT, PLEASE CALL 1 (732) 738-9003 FOR
GEMINI CUSTOMER SERVICE. DO NOT ATTEMPT TO RETURN THIS EQUIPMENT TO YOUR DEALER.
(6)
ROBO START INSTRUCTIONS:
IN SINGLE-AUTO CUE MODE:
Use ROBO START(26) in SINGLE-AUTO CUE MODE(18) to alternate
play between the CDX-04’s two CD players (one track from one side,
then one from the other). In SINGLE-AUTO CUE MODE(18) play starts
immediately with no blank or “dead” space. ROBO START(26)
causes one side of the CD player to play when the other side is
paused.
1. Engage SINGLE AUTO CUE MODE(18) with the SINGLE(18) button.
2. Press the ROBO START(26) button to activate ROBO START. Play will
alternate between the two CD players. At the end of a track, the
playing side pauses and the other CD deck plays a track. At the end of
this track, the playing side pauses and the first deck resumes play.
IN CONTINUOUS MODE OR DURING NORMAL PLAY:
If you use the ROBO START(26) function without SINGLE-AUTO CUE
MODE (in CONTINUOUS MODE or during normal play), CD deck does
not alternate automatically. The PLAY/PAUSE(12) button must be
pressed on the playing deck for the second track to play.
1. During normal play, set a CUE POINT on the other side of the CD
player.
2. Press the ROBO START (26) button to activate ROBO START (the
button will blink).
3. Press PLAY/PAUSE (12) button on the playing side to begin play from
the cue point on the other side.
NOTE: IF PAUSED DURING PLAYBACK, IN THE MIDDLE OF A TRACK. WHEN THAT TRACK
ENDS, PLAY WILL BEGIN FROM THE MIDDLE OF THE TRACK WHERE PLAY WAS
PAUSED.
TROUBLESHOOTING:
If the disk will not play, check to see if the disc was loaded
correctly (label side up). Also, check the disc for excessive dirt,
scratches, etc.
If the disc turns but there is no sound, check the cable
connections. If they are okay, check your amplifier or receiver.
If the CD skips, check the CD for dirt or scratches. Do not
assume that the CD player is defective. CDs that are recorded
improperly tend to skip on most or all CD players. Before
sending the unit in for repair playa CD that you are sure plays
properly.
SPECIFICATIONS:
GENERAL:
Type................................................................... ........Compact Disc Player
Disc Type......................................Standard Compact discs (12 cm & 8 cm)
Time Display.........................Track Elapsed, Track Remain, or Total remain
Variable Pitch.............................. .
±
4, 8 ,16 %
Slider with Resume Switch
Pitch Bend..........................................................................± 4% Maximum
Instant Start..................................................................Within 0.03 seconds
Track Selection.......................................................................1 to 99 Tracks
Installation......................................................................................19" each
Dimensions..........................................................................19" x 3.5" x 10"
Weight entire Unit................................................13.69 lbs. (6.21 kg)
AUDIO SECTION:
Quantization........................................1 Bit Linear/Channel, 3 Beam Laser
Oversampling Rate..........................................................................8 Times
Sampling Frequency.......................................................................44.1 kHz
Frequency Response..........................................................20 Hz to 20 kHz
Digital Output....................................................................................IEC958
Total Harmonic Distortion..................................................Less Than 0.05%
Signal to Noise Ratio.........................................................................85~86 dB
Dynamic Range..................................................................................85~90 dB
Channel Separation...............................................................85~86 dB
Output Level........................................................................2.0 +/- 0.2 V R.M.S.
Power Supply...........................................................AC 115/230V, 60/50 Hz
SPECIFICATIONS AND DESIGN ARE SUBJECT TO CHANGE WITHOUT NOTICE FOR
PURPOSE OF IMPROVEMENT
.