Filter
Top Products
Troubleshooting
309909H 11
Paint does not cure consistently. Ratio not set correctly. Check that correct ratio is set and set by
volume. See ProMix Easy Operation
manual.
Material not mixing correctly. Test pump. Page 9.
Make sure mixer is clean; flush as
needed. See ProMix Easy Operation
manual.
Pump not operating correctly. Observe whether pumps are loading and
checking correctly, if not, clean and repair
pump. See displacement pump manual
310662.
Poor spray pattern. Fluid pressure too low. Increase pump pressure.
Spray tip dirty or worn. Relieve pressure. Clean or replace tip.
Follow gun manual instructions.
Fluid A or B filters plugged. Clean filters.
Mixer or hoses partially plugged or too
restrictive.
Inspect parts for cured material. Clean or
replace, or use larger hoses and mixer.
System runs erratically. Air filter(s) clogged. Replace elements. Clean. Replace element(s). See page 15.
Air supply hoses undersized. Replace hoses with appropriate size.
Air compressor undersized. Use larger air compressor.
Air supply pressure tank undersized. Use larger pressure tank.
Air supply relief valve opens. Turbine air regulator set too high. Lower setting to 23-25 psi (172-241 kPa,
1.7-2.4 bar).
Turbine alternator makes high-pitched
whining noise.
Turbine bearings worn. (Setting turbine
air regulator too high, wears bearings.)
Replace bearings. Page 19.
Display shows 88888 or unit reboots
unexpectedly.
Turbine is not supplying enough power to
board.
Increase turbine regulator setting to
23-25 psi (172-241 kPa, 1.7-2.4 bar).
Check turbine and electrical control
exhaust air for restrictions.
Replace turbine bearings. Page 19.
ProMix Easy does not start when start
button is pressed.
Faulty start switch or wire harness. Check start switch and wiring harness
continuity; switch is normally open circuit.
See Electrical Schematic, page 22.
Faulty stop switch or wiring harness. Check stop switch and wiring harness
continuity; stop switch is normally closed
circuit. See Electrical Schematic, page
22.
Bad I/O port on display board. Replace board. Page 18.
Bad I/O port on main board. Replace board. Page 17.
Dispense valves leaking. Loose or worn packings. Tighten packing nut. If leak continues,
replace packings. See 310655.
Problem Cause Solution