Filter
Top Products
NOTE: If preparing the rails for integrated shipping,
follow the same instructions as in "Installing the UPS
("Installing the UPS in a rack" on page 3)."
NOTE: Mounting hardware for square- and round-holed
racks is included in the UPS kit.
1. Loosen the wing nuts or hex nuts, and then extend the brackets
to the desired length.
2. Insert screws through the rack into the mounting rail and the
front of each mounting bracket.
3. Install cage nuts or clip nuts into the rear of the rack.
4. Insert screws through the mounting rail into the cage nuts or
clip nuts.
5. Tighten the wing nuts or hex nuts.
6. Install the rear stabilization bracket using wing nuts. Wait until
the unit is installed and the brackets are adjusted before
tightening the nuts.
Installing the UPS in a rack
Before installing the unit, review and adhere to all warnings
provided in "Precautions (on page 1)."
WARNING: Uneven mechanical loading in the rack may
cause a hazardous condition