Kenwood AUDIO PROCESSOR Musical Instrument User Manual


 
FRONT PANEL CONTROLS
(14) EFFECTS PROCESSOR DELAY Potentiometer (R42)
This potentiometer works only if the Effects Processor 3 position
toggle switch is selecting either effect 1 or effect 2. The Delay
control, when rotated clockwise increases, by up to about
80 milliseconds, the time that audio waveform is delayed. The
delayed waveform is then mixed with the original non delayed
waveform. The mixed waveform is next sent to the output of
the EQplus.
When the pot is turned clockwise, at the halfway point, there is a
detent. This represents a starting point for adjusting the Effects
Processor Delay..
(15) EFFECTS PROCESSOR LEVEL Potentiometer (R47)
This potentiometer works only if the Effects Processor 3 position
toggle switch is selecting either effect 1 or effect 2. The Level
control, when rotated clockwise, increases the amplitude that
the delayed audio waveform is combined with the original non
delayed waveform.
When the pot is turned clockwise, at the halfway point, there is a
detent. This represents a starting point for adjusting the Effects
Processor Level.
(16) OUTPUT LEVEL Potentiometer (R44)
This potentiometer varies the output level from about 10
millivolts to about 1 volt peak to peak.
(17) Monitor (Mon) LEVEL Potentiometer (R39)
This potentiometer adjusts the audio level into the Phones
Connector (24).
-9-