Filter
Top Products
MS2000/MS2000R EasyStart
4
4. Now let’s add a second SEQ by Motion sequencing Filter Cutoff
Ä
ÄÄ
Ä Press the SEQ EDIT [SELECT] key so that the SEQ 2
LED is lit. On the lower line of the LCD screen you will see there is no parameter assigned to SEQ 2. SEQ2:None
5. Press the MOD SEQUENCE [REC] key, play a note or chord while rotating the FILTER CUTOFF knob. (Recording will
automatically stop after the last step)
Ä
ÄÄ
Ä Now hold a chord and listen to your first MOD SEQUENCE! If you don’t like what
you’ve done, you can overwrite it by pressing [REC] and giving it another go, or you can adjust it step by step using the 16
knobs.
! In the UTILITY page 26G, you can Copy ALL MOD Sequences from one Program to another. The UTILITY pages also provide
procedures for Initializing Programs, Timbres, and MOD Sequences, and for Copying and Swapping Timbres and MOD Sequences.
! Many of the factory programs contain Mod Sequence data. These programs are great examples: A02, A14, B06, C14. For more detailed
information on Mod Sequencing see pages 16, 25, and 42 of the Owner’s Manual.
The Vocoder & Modifying external waveforms using the Audio Inputs
The MS2000 has two audio inputs. AUDIO IN 1 is for connecting a synthesizer or other audio source. The input signal can be used
as the oscillator 1 waveform, allowing you to modify the audio source using the FILTER, AMP, EG and LFO knobs and apply effects.
AUDIO IN 2 is the microphone input for the vocoder programs or it can be used together with the AUDIO IN 1 jack if you are
plugging in a stereo source. Let’s try it!
1. Make sure the AUDIO IN 1/INST and AUDIO IN 2/VOICE knobs on the MS2000 are turned all the way down.
2. Connect a microphone to the rear panel AUDIO IN 2 jack and set the AUDIO IN 2 level switch to the MIC position.
3. Slowly adjust the AUDIO IN 2/VOICE knob up until the LED turns green (red indicates clipping) when you speak into the
microphone.
4. Now select program H15:AudioIn INIT. Press a note on the keyboard
Ä
ÄÄ
Ä Speak into the microphone while adjusting the
FILTER CUTOFF and RESONANCE knobs
Ä
ÄÄ
Ä Select different filter types with the [FILTER TYPE] key Ä
ÄÄ
Ä Try turning on (lit)
the [MOD/DELAY] in the EFFECTS section and adjusting the SPEED/TIME and DEPTH/FEEDBACK knobs. Nice.
5. Now let’s try some of the Vocoder programs. Select program H09:Vocoder Ens and speak into the microphone while
playing several chords on the keyboard
Ä
ÄÄ
Ä Try programs H10: Vocoder Cho, H11:Vocoder Wah, H12:VocoderPulse,
H13: VoiceChanger, H14:Vocodevil.
! For more in-depth information on working with the Vocoder, see the Owner’s Manual pages 4, 17, 28, 34 and 49.