Filter
Top Products
37
■ Reloading the Saved Data
1. Run a MIDI cable from the MIDI IN connector on the piano to the
MIDI OUT connector on the data filer or (or other storage device)
where the saved data is stored.
2. On the piano, hold down TRANSPOSE/FUNCTION and press
STRINGS/CHOIR.
+
The two buttons begin flashing, indicating that the piano is now
standing by to receive the data.
If you want to cancel at this time without transferring the data:
Press
either TRANSPOSE/FUNCTION or STRINGS/CHOIR.
3. Go to the data filer and carry out the operations required to start
transfer of the saved data to the piano. (Refer to the data filer's
instruction manual.)
4. The piano receives the data.
When the transfer is completed, the flashing TRANSPOSE/FUNCTION
and STRINGS/CHOIR go dark and the piano returns to normal
operating mode.
Please don't touch any of the piano's buttons or controls while data transfer
is in progress.
The piano keyboard is disabled (the piano will not produce any sound)
during standby and transmission.