Filter
Top Products
9
Getting Ready to Play
Getting Ready
■ Connect the power.
Connect the socket end of the AC power cord to the piano’s AC IN
connector. Then plug the other end of the power cord into a wall power
outlet.
■ Raise the keyboard cover. (NC-500 only)
Lift the front edge of the cover near the center of the keyboard, and
slide the cover all the way back into the cabinet.
To close the cover
: Lift the cover in the same location, and gently pull
it all the way out. Lower the front edge of the cover.
Be careful to avoid snagging your hand or your fingers when opening or
closing the cover.
Handle the cover gently and don't try to force it. The cover may break if
mishandled.
Before raising the cover, be sure that there are no small objects (such as coins
and paper debris) resting on it. Such objects can fall inside the piano when
the cover is lifted.
■ Turn on the power.
Press the POWER switch to turn the power on.
The selected SOUND button, the BANK button, and various other buttons
on the front panel light up.
To turn the power off:
Press the POWER switch once again.
Turning the power off returns all settings to their factory defaults. The NC-
500’s recorder memory will retain any song data that has been recorded.