Filter
Top Products
Advanced settings | Calibrating the pedals – 31
English
CALIBRATING THE PEDALS
You can calibrate the pedals connected to the DAMPER, PEDAL 1 and PEDAL 2
connectors in the back panel. By calibrating a pedal, you let the SV-1 understand
its polarity and the full range of values sent.
1. Connect all pedals to be calibrated to the SV-1. Remember that DAMPER
expects the included Korg DS-2H damper pedal, PEDAL 1 expect a foots-
witch-type pedal, and PEDAL 2 can be used to connect either a footswitch or
expression-type pedal.
2. Set any expression-type pedal to its lowest setting.
3. Turn the SV-1 off.
4. Keep the AUTO/PEDAL button pressed, and turn the SV-1 on.
5. When the AUTO/PEDAL LED starts to flash, release the button.
If you do nothing in the next few seconds, the AUTO/PEDAL LED will turn
off, and the SV-1 will complete the start-up sequence.
6. While the AUTO/PEDAL LED is flashing, press the button again. SV-1 enters
calibration mode.
7. Now calibrate PEDAL 1 (a footswitch). Completely depress the pedal, then
release it. When you have finished calibrating the pedal connected to the
PEDAL 1 jack, FAVORITE button #1 will turn on.
8. Then, calibrate PEDAL 2. The procedure is different, depending on the use of
a footswitch or an expression pedal:
• If you connected a footswitch, completely depress it, then release it.
• If you connected an expression pedal, push it all the way forward to its max-
imum position, then return the pedal to its minimum or lowest position.
When you have finished calibrating the pedal connected to the PEDAL 2 jack,
FAVORITE button #2 will turn on.
9. Finally calibrate the DAMPER pedal. Completely depress the pedal, then
release it. When you have finished calibrating the pedal connected to the
DAMPER jack, FAVORITE button #3 will turn on.
10.When finished calibrating:
• If you calibrated all three pedals connected, SV-1 automatically exits cali-
bration mode and continue the start-up sequence.
• If you calibrated only one or two pedals, press the AUTO/PEDAL button
again to exit calibration mode and continue the start-up sequence.
SV1-100-UserGuide-EFGI.book Page 31 Tuesday, June 30, 2009 9:23 AM