Filter
Top Products
ON
OFF
POWER
FUSE: T8A / 250V
120V 60Hz 160W
AC FUSE
MODEL KPM8420
POWERED MIXER
SPEAKERSA B
50
49
53
51
52
POWER AMP OUTPUTS, AC POWER
POWER AMP OUTPUT AC POWER
POWER ON / OFF Switch:
SPEAKERS A:
The KPM8420 is ON when the switch is in the UP
These two ¼” jacks deliver the power from the A
position. Press the switch to the DOWN position to
power-amp to the speakers.
turn the KPM8420 off. Always remove the AC
plug from the wall when not in use.
SPEAKERS B:
These two ¼” jacks deliver the power from the B
AC Power Cord Receptacle:
power-amp to the speakers.
Insert the AC cord (Provided) firmly into the AC
connector. NOTE: Replace the AC power cord if
MINIMUM LOAD (Impedance) Per Channel:
protective jacket is damaged or ground pin is
4 OHMS
damaged or removed.
POWER RATING Per Channel:
FUSE:
The fuse is located in a housing just below the
receptacle. Replace only with same type and size.
Caution: Use speakers rated at 125 Watts @ 8
To remove the fuse, pull the tab located above the
ohms or higher. Severe damage to the speakers is
fuse symbol away from the fuse housing.
possible if too low of wattage speaker is used.
200 Watts@4 ohms, 125 Watts@8 ohms. Both
amps driven to 100%
10