Filter
Top Products
Basic Operation
Lexicon
2-2
SELECTING AND LOADING PROGRAMS
When powered on, the unit will load the last program
that was loaded during the previous operating session.
To select another program, turn the front panel
PROGRAM knob.
When the PROGRAM knob is turned clockwise, the unit
will cycle forward through programs in the selected
bank, then proceed to cycle forward through programs
in the next bank. When turned counterclockwise, the
unit will cycle backward through programs in the
selected bank, then proceed to cycle backward through
programs in the previous bank. When the PROGRAM
knob is pushed inward and turned, the unit will cycle
through program banks.
The name and number of the selected program appear
on the front panel display (see page 1-6). The
Load LED will light to indicate that the selected
program is cued for loading. After 4 seconds,
the front panel display will revert to showing the name
and number of the loaded program. However, the Load
LED will remain lit to indicate that the selected program
is still cued for loading. The number of the cued program
will appear in inverse video below the number of the
currently loaded program. To load the cued program,
press the front panel Load button.
The unit can be configured to automatically load
programs 3/4 second after the PROGRAM knob stops
turning. To do this, set the System Mode parameter Auto
Load to Enabled (see page 3-7).
Turn the PROGRAM knob clockwise to
cycle forward through all programs.
Turn the PROGRAM knob counterclockwise to
cycle backward through all programs.
Press and turn the PROGRAM knob to
select a program bank.