Filter
Top Products
Reference Manual D AD 3220 B Version 1.0
Page 16
Switch Function Detail
All settings are stored in Flash Ram inside the
module (see Auto Store section in this manual).
Settings will be recalled on power up.
Dip Switch 1
This switch enables local control using the dip-
switches. ON enables local control and makes
selections on the dipswitch active, and OFF
disables local control (locking out any local
changes)
Note.
When Switch 1 is initially switched to ON, the static
settings currently set on the dip-switches may not
reflect the actual configuration stored in the
module. This is because all settings can be
changed from the remote control system or via the
Service Adapter. This overrides the local dip
switches regardless of Switch 1 ON/OFF setting. To
ensure the module reads the local dip switch
settings it is recommended to toggle Switch 1 ON-
OFF-ON before making any local changes to the
dip switches
.
Dip Switch 2
This switch selects the mode of operation for the
module. ON selects dual 1 into 4 mode where each
individual AES input is distributed to four outputs.
OFF selects 1 into 8 mode where input AES in 1 is
distributed to all 8 outputs.
Dip Switch 3
This is not used
Dip Switch 4
This is not used