Mackie PPM1008 Music Mixer User Manual


 
7
Owner’s Manual
Owner’s Manual
House of Worship System
This diagram shows microphones attached to the mic inputs of channels 1 to 4, an electric guitar con-
nected directly to channel 5 (with hi-z switch pressed in), an acoustic guitar mic connected to channel 6
mic in, a keyboard attached to channel 7's stereo inputs, and a drum machine to channel 8.
A Mackie SRM150 powered monitor is connected to the monitor 1 send, and acts as a personal stage
monitor to the keyboard player. The mon 1 knobs of each channel allow you to set up a monitor mix that
is independent of the main mix.
The power amp mode switch is set to play the mono main mix on ch. A, and monitor 1 mix on ch. B.
Mackie S215 passive speakers are connected to the channel A speaker-level power output of the pow-
ered mixer, and they play the main mono mix to your audience.
S218s subwoofers are powered by a Mackie FRS2800 amplifi er connected to the main mix sub out, to
reinforce the low end in your main mix.
C300z passive stage monitors are connected to the channel B speaker-level power output of the pow-
ered mixer. These play the stage monitor mix 1 to your performers.
Microphones
press HI-Z
button
Keyboards
Drum
Machine
S215 Passive Speakers
House System
(plays mono main mix)
C300z Passive Stage Monitors
(plays mon 1 output)
FRS2800
Amplifier
dual-mono
mode
Rear Panel
Front Panel
Power Amp Mode
switch set to
Mains/Mon 1
Adjust
Vocal
Compression
SRM150 Powered Monitor
(plays mon 1 output)
S218s Passive Subwoofers
(plays main mix below 100 Hz)
Acoustic Guitar
and Mic