11
Specifications
MGT-16 SYSTEM
Frequency Response 50Hz–16kHz (-3dB)
Dynamic Range 120dB
Oscillating System Phase Lock Loop (PLL)
Total Harmonic Distortion (THD) <0.8%
RF Carrier Frequency Range 902.40MHz–923.70MHz
Modulation FM (F3E), +/-30KHz normal
Operating Range Up to 250 feet (typical, depending on site conditions)
MGT-16 RECEIVER
Controls Audio Level, Power ON/MUTE/OFF,
Frequency Select DIP-switches, IR sync button
Connectors Unbalanced ¼”, DC Adapter input jack
LED Indicators Power ON (Red-continuous), Low Power (Orange-continuous),
RX reception (Green)
Antennas Dual ¼ wave, adjustable orientation
Signal-to-Noise Ratio >105dB (w/AC/DC power supply)
Receiver Sensitivity -110dBm nominal, 12dB SINAD
Squelch Sensitivity -95dBm (minimum/normal setting), adjustable
Output Impedance 1.0KΩ
Power Consumption DC: 3V/ 115mA or AC/DC adapter: 10VDC/200mA
Battery Two AA alkaline or NiMH
Battery Life Up to 8 hours
Dimensions 2.75” W x 5.00” D x 1.88” H (7.0 cm x 12.7 cm x 4.78 cm)
Weight (w/o batteries) 5.7 oz (161.6 g)
Housing Construction ABS Plastic
MT-16A/R TRANSMITTER
RF Power Out 25mW nominal, 50mW maximum
Harmonic & Spurious Emissions -50dB
Controls Power ON/OFF, 15dB Attenuation Pad select switch
LED Indicators Power ON (Red-single flash), Low Battery (Red flash)
Input Impedance 500KΩ
Power Consumption DC 1.5V/90mA
Battery One AAA alkaline
Battery Life Up to 8 hours
Antenna ¼ wave, permanently attached
Dimensions MT-16A: 4.5” W x 2.0” D x 1.0” H (11.43 cm x 5.08 cm x 2.54 cm)
MT-16R: 3.5” W x 2.5” D x 1.0” H (8.9 cm x 6.35 cm x 2.54 cm)
Weight (w/o batteries) MT-16A: 1.2 oz (34 g)
MT-16R: 1.1 oz (31.2 g)
Housing Construction ABS Plastic
Specifications subject to change at any time without prior notice for purposes of product improvement