Filter
Top Products
7
IR Sync Selected Frequency Download
from MGT-16 Receiver to MT-16A/R Transmitter
(1) ASC
™
IR SYNC INFRARED LED WINDOW
For downloading selected Channel
(Frequency) to transmitter
(21) IR RECEPTOR SENSOR/WINDOW Infrared LED
sensor for linking the TX to the RX during
IR frequency download.
14. ASC
™
IR SYNC BUTTON Press to make the IR link
download the receiver’s selected frequency to
the TX. First, turn on the MT-16A/R transmitter
(or turn off and then on again if already on) and
position its IR window 6-12” away from the
RX IR window, press the SYNC button once
and wait one second for the RX to respond.
If the IR data download is successful, the
receiver SIGNAL LED (10) will light indicating
the transmitter is locked in and transmitting.
1
POWER
IR PO LO RX
OFF ON
14
ACT SQ
21
15 dB PAD
System Operation
MGT-16 Wireless Instrument Receiver
Antennas
The MGT-16 receiver is supplied with
Dual Antennas (9) attached. They should be
extended fully to obtain maximum range.
The optimal positions of the antennas are
45 degrees from the receiver and 90 degrees
from each other. For maximum range, it is
always best to maintain a line-of-sight (no
obstructions) between the receiver antennas
and the transmitter whenever possible.
Powering the Receiver
The MGT-16 receiver can operate with either
two AA size batteries (DC operation) or with
the supplied AC adaptor (AC operation).
For DC operation, open the receiver’s
Battery Compartment Door (6) and place
two fresh AA batteries in the battery
compartment, observing the correct polarity.
Two fresh alkaline or NiMH AA batteries will
generally provide 6-8 hours performance,
but in order to ensure optimal performance
it is recommended that the batteries
be replaced after six hours of use, or as
indicated by the Low Battery Indicator (11).
As the batteries begin to weaken below
usable voltage, the low battery indicator
will light up continuously, warning that the
batteries are now too low and should be
replaced as soon as possible. To preserve
battery life, keep the receiver Off when it
is not in use.
For AC operation, power the receiver with
the supplied AC Power Adaptor (16). Plug the
adapter’s barrel plug into the DC Input Jack (8)
on the back of the receiver, then plug the
adapter into an AC outlet.
AC operation of the MGT-16 receiver is
the same as DC operation except that the
Low Battery Indicator is inactive when the
AC adapter is connected.
Note: When the AC adapter is used, the installed
batteries are automatically disconnected internally
and are not operational. The AC adapter only