Filter
Top Products
1. ASC
™
IR SYNC INFRARED LED WINDOW
For downloading selected Channel
(Frequency) to transmitter
2. POWER SWITCH Select OFF/MUTE/ON
(MUTE=power On, audio output highly
attenuated)
3. VOLUME CONTROL Adjusts the audio output
level—at maximum setting the gain will
be about +4dB over a direct instrument-to-
cord-to-amp connection
4. CHANNEL SELECT DIP-SWITCH Select one of
16 pre-set channels per MGT-16 DIP-Switch
Frequency Selection Chart (see page 14)
5. BATTERY COMPARTMENT Insert two AA
batteries for optional DC operation,
note correct polarity
6. BATTERY COMPARTMENT COVER
7. AUDIO OUTPUT JACK For connecting audio cable
8. DC INPUT JACK For connecting external AC/DC
adapter for powering receiver
9. ANTENNAS Dual ¼ wave
10. SIGNAL LED Indicates the received signal
from the transmitter
11. LOW BATTERY LED Indicates batteries need
replacement (if not using power adapter)
12. POWER ON LED Indicates the receiver is On
13. MUTE (SQUELCH) CONTROL Adjust with a small
screwdriver inserted in slot. Controls the
mute level for the receiver—turn counter-
clockwise for maximum range; turn clockwise,
if needed, to minimize noises from outside
RF interference upon muting.
Note: Set control carefully. If trim-pot
is turned past minimum and maximum
adjustment points it may need to be backed
up to achieve desired setting.
14. ASC
™
IR SYNC BUTTON Press to make the IR link
download the receiver’s selected frequency to
the TX. First, turn on the MT-16A/R transmitter
(or turn off and then on again if already on) and
position its IR window 6-12” away from the
RX IR window, press the SYNC button once
and wait one second for the RX to respond.
If the IR data download is successful, the
receiver SIGNAL LED (10) will light indicating
the transmitter is locked in and transmitting.
15. AA BATTERIES Two required for optional battery
operation
16. POWER ADAPTER For AC operation (included)
5