Filter
Top Products
13
Escort
®
Specifications:
Output Power: 150 Watts per channel into 8 Ohm load
Frequency Response: 40 Hz to 20 kHz +0/-3 dB measured at 1 Watt
Overload Protection: DDT™ (Distortion Detection Technology) limits the power amplier input to prevent clipping distortion
that can damage speakers.
Distortion: Less than 0.1% THD
Max Gain: 86 dB mic input to speaker output
Signal/Noise Ratio: 85 dB mic input typical
Reverb: Digital
AC Power: 115 VAC 60 Hz or
230 VAC 50/60 Hz
Weight Assembled: 50 lbs. (22.67 kg)
(Stands Included)
Dimensions: 14.5” H x 36.75” W x 15.5” D
(36.8 cm x 93.3 cm x 39.4 cm)
Speakers: Woofer 10” (254 mm)
Piezoelectric Horn Tweeter
Microphone: Dynamic, Cardioid (Unidirectional)
Escort 3000 Troubleshooting Guide
Problem Check Correction
No sound
(no power light)
Is power switch on?
Is line cord connected to live power outlet?
Turn power switch on
Connect power cord to live outlet
No sound
(power light on)
Are MASTER and CHANNEL GAIN controls up? Adjust both MASTER and CHANNEL
GAIN controls upward to desired
level. Check speaker connections.
Turn mic switch on. Check mic or
sound source connection.
Only one speaker works
If it goes away when the CHANNEL or MASTER volume
controls are lowered, it is acoustic feedback
Fully insert connection and/or swap
speaker cables between left and
right speakers and outputs to check
for damaged cables. Set CHANNEL
5 MODE switch to LEFT OR RIGHT or
use LEFT INPUT on CHANNEL 4.
Are both MASTER controls turned
up?
Mono line source into CHANNEL 4 or 5?
Loud howling or squeal from speakers
Reduce microphone gain. Reposition
microphone behind or farther from
speakers. Observe FLS light above
EQ and reduce level of that band.
Sound is distorted Is the CHANNEL GAIN at a very high setting? Reduce CHANNEL GAIN and increase
MASTER VOLUME