Filter
Top Products
8
REMOTE VOLUME (22)
The master level of the mixer can be controlled remotely with a simple connection on the back of the unit. A
10 K to 100 K potentiometer can be wired as shown in the drawing below. A 10 K pot will provide approxi-
mately 0 to 25 dB of attenuation. A 100 K pot will provide 0 to 45 dB of attenuation. If desired, a control
voltage can be inserted to command 0 to 70 dB of attenuation. The internal gain trim must be set full CW to
achieve the maximum attenuation range of the remote volume.
NOTE: The control voltage should never exceed 13 volts DC.
figure 4 Remote Volume
LINK PORT (23)
To increase the number of inputs available, multiple Peavey Automix's can be linked together. Linking
automixers is a very simple process. It can be done with a small flathead screwdriver and a length of two
conductor shielded wire.
a. Using the small screwdriver, remove the factory installed jumper wires in the link port from the slave
unit.
figure 5 Link Port
b. Connect the mixers with the shielded wire as shown.
figure 6 Link Port
SHIELD
remove »
remove »
»
»