Filter
Top Products
Generalmusic PRO 1/PRO 2 Page 39
7. When you have finished, press Play/Stop to stop the recording.
• The instrument will remain in Record mode.
• The recorded track is confirmed (the relative LED stops flashing and remains permanently on.)
NOTE: If you pressed REC to exit record mode at this point, you could play along with the recorded
track using any sound of your choice.
8. Press the Track 2 button.
• The led above the button starts to flash. You may select a sound for the new track a this stage.
9. Press the Play button to start recording.
• Track 1 will playback allowing you to record Track 2 in time with Track 1.
10. When you have finished recording Track 2, press the Play/Stop button to stop recording.
• The second track will be confirmed automatically.
11. Press the Rec button to exit Record mode.
• The LED indicators of the recorded tracks will remain permanently on.
NOTE: The sequencer records the initial program changes and any sound changes you make during recording.
Playing back the recording
To play back the recording, press Play/Stop.
• During playback, you can deactivate/activate the track of your choice and play along with one or two
sounds in real time. Select the Sounds using the normal selection procedure.
• You can deactivate the track of your choice before starting playback.
Overdubbing
The PRO 2 allows you to record in Overdub mode, letting you add additional events to those already recorded.
• After recording a track, press Pause to stop the recording.
• Press the Rewind button to take the track to the beginning (or to any point before the stop point).
• Press Pause again to start recording from your “cue point”. Anything you now play will be merged
with the previously recorded events.
Erasing
You can cancel the Song entirely or partially by using the Erase function.
Partial Erase
Hold the Erase button and press the track button that you want to erase for about 2-3 seconds.
The relative LED above the erased track goes off.
Erase all
Hold the Erase button and press both Track buttons simultaneously. The LED indicators above both
buttons will go off.