Filter
Top Products
10
En
Basic Operation
Starting the system
Starting this unit
1 Connect this unit to your computer via a USB cable.
ON OFF PHONES
2 Boot up the connected computer.
3 Slide this unit’s [ON/OFF] switch to the [ON] position.
ON OFF PHONES
Turn on the power of this unit.
! The message [Installing device driver software] may appear when
this unit is first connected to the computer or when it is connected to
a different USB port on the computer. Wait a while until the message
[Your devices are ready for use] appears.
Launching VIRTUAL DJ LE
When this unit has just started, wait for the illumination to stop before
launching VIRTUAL DJ LE.
Launching VIRTUAL DJ LE (Windows)
1 From the Windows [Start] menu, click the [All
Programs] > [VirtualDJ] > [VirtualDJ LE (DDJ-WeGO)]
icon.
2 Click [CONFIG] in the top right of the computer’s
screen.
The [Settings] screen appears.
Settings should be selected on the [Sound Setup] tab in the following
order:
1 [Inputs]: Select [NONE].
2 [Sound card]: Select [ASIO DRIVER] and
[Pioneer DDJ_WeGO ASIO].
3 [Outputs]: Select [HEADPHONES] and
[Master: Chan 1&2/Headphones: Chan 3&4].
3 Click [Apply], then click [OK].
Launching VIRTUAL DJ LE (Mac OS X)
1 In Finder, open the [Application] folder, then double-
click the [VirtualDJ LE] icon.
When VIRTUAL DJ LE is launched the first time, a screen for entering the
serial number appears.
Input the serial number printed on this unit’s bottom panel (XXXX-
XXXX-XXXXX/WEGO), then click [OK].
2 Click [CONFIG] in the top left of the computer’s
screen.
The [Settings] screen appears.
Settings should be selected on the [Sound Setup] tab in the following
order:
1 [Inputs]: Select [NONE].
2 [Sound card]: Select [4-OUT CARD] and [Pioneer DDJ-WeGO].
3 [Outputs]: Select [HEADPHONES] and
[Master: Chan 1&2/Headphones: Chan 3&4].
3 Click [Apply], then click [OK].