Filter
Top Products
DRB1493-B
En
6
6
Connections
Be sure to turn off the power and unplug the power cord from the power outlet whenever making or changing connections.
Refer to the operating instructions for the component to be connected.
Connect the power cord after all the connections between devices have been completed.
Rear Panel
MASTER1
MASTER2
CH-4
ZONE
1 GND
1 GND
3 COLD
3 COLD
2 HOT
2 HOT
MASTER AT T.
-
12dB
-
6dB
0dB
-
12dB
-
6dB
0dB
ZONE AT T.
CD
L
L
L
L
RR
R
R
R
LINE
CH-3 CH-2 CH-1
DJM-
5000
CD CD
L
R
L
LINE
REC OUT
L
R
BOOTH
TRS
CONTROL
CD
R
L
CONTROL
SEND
L
(
MONO
)
R
L
(
MONO
)
R
L
R
RETURN
DIGITAL IN USB
21
MIC 3
MIC 2
1
6 72
3 3 4 4
4 4 5 5
16 141517 13 12 11 10
9 8
1 ZONE (page 7)
An output terminal for the ZONE channel.
2 ZONE ATT
Use to switch the attenuation level of audio signals output at the [ZONE]
terminal. Select from 0 dB, -6 dB and -12 dB.
3 LINE (page 7)
Connect to a cassette deck or a line level output component.
4 CD (page 7)
Connect to a DJ player or a line level output component.
5 CONTROL (page 7)
This is a control terminal for a DJ player. Use the fader of this unit to control
a DJ player.
6 MIC3 (page 7)
Connect to a microphone.
7 MIC2 (page 7)
Connect to a microphone.
8 USB (page 8)
Connect to a computer.
9 DIGITAL IN (page 7)
Connect to a digital audio output component.
a RETURN (page 7)
Connect to the output terminal of an external effector. When the [L] channel
only is connected, the [L] channel input is simultaneously input to the [R]
channel.
b SEND (page 7)
Connect to the input terminal of an external effector. When the [L] channel
only is connected, a monaural audio signal is output.
c BOOTH (page 7)
Output terminals for a booth monitor, compatible with balanced or unbal-
anced output for a TRS connector.
d REC OUT (page 7)
This is an output terminal for recording.
e MASTER2 (page 7)
Connect to a power amplifier, etc.
f MASTER ATT
Use to switch the attenuation level of audio signals output at the [MASTER1]
or [MASTER2] terminal. Select from 0 dB, -6 dB and -12 dB.
g MASTER1 (page 7)
Connect to a power amplifier, etc.
h AC IN
Connect the supplied AC power cable to the AC IN inlet, then plug into a
power outlet. Plug in the power cable after all connections have been made.