Filter
Top Products
7
<DRB1314>
MIC 2MIC 3CH-4CH - 1CH - 2CH - 3CH - 4
CONTROLCONTROLCONTROLCONTROL LINE 1LINE 3LINE 5LINE 7
LINEPHONO
LINEPHONO
LINEPHONO
LEVEL
LEVEL
ATT .
MASTER
TALK OVER
SIGNAL
GND
/ LINE 2/ LINE 4
PHONO 1PHONO 2
/ LINE 6
PHONO 3PHONO 4
R
L
R
L
R
L
R
L
R
L
L
L
R
RLR
RL
(MONO)
RL
(MONO)
LR12
BOOTHMASTER
MASTER OUT 2
MASTER OUT 2
DIGITAL OUT
REC OUT
SEND
SEND
RETURN
RETURN
OUT 1 MONITOR
BOOTHMASTER
OUT 1 MONITOR
1 GND
2 HOT
3 COLD
CH - 1
CH - 2
CH - 3
CH - 4
LINE 1
LINE 3
LINE 5
/ LINE 2
PHONO 1
/ LINE 4
PHONO 2
/ LINE 6
PHONO 3
LINE 7PHONO 4
RLR L
R L
DJM-3000
1
2
3
DJM-3000
CONNECTIONS
2. Connection of Outputs, Microphones, etc.
Microphone 1
Headphones
Power amplifier
(Supports RCA input)
Power amplifier
(For booth monitor)
MIC 3
(CH-4 PHONO 4 cannot
be used when
microphone is connected
to MIC 3.)
XLR terminal polarity is as
shown in the diagram below.
COLD (–)
GND
HOT (+)
Power amplifier
(Supports XLR input)
Cassette deck, etc.
External effector
*6 MASTER LEVEL ATT.
(Master output-level attenuator shaft)
This shaft is used to decrease the output level to protect
connected amplifiers and speakers from excessive input.
(Attenuation: –∞ to 0 dB)
*7 Connect if you want to use another device for adjusting
sound quality.
SEND (output):
Connect this to the external effector’s input terminal.
When using a monaural input effector, connect it to the L
channel output. The effector will receive LR-mixed sound.
RETURN (input):
Connect this to the external effector’s output terminal.
When using a monaural output effector, connect it to the
L channel output. The signals from the effector will be
input to both the L and R channels.
*8 REC OUT
Outputs sound to the same output source as the master
output, without being influenced by the master volume,
master balance and MONO/STEREO switches.
*9 TALK OVER LEVEL attenuation control
Attenuates sound level from sources other than MIC 1
and 2 when the MIC switch is set to the TALK OVER
position (range: –4 to –20 dB).
*10
MIC 1
Supports microphones with either XLR or PHONE type
jacks.
*11
DIGITAL OUT
Outputs same source as the master output.
The output level is not affected by MASTER LEVEL ATT.
(*6).
Microphone 2
CD recorder, etc.