Filter
Top Products
Mono Input Channel Controls
6 – Pyle Pro Mixer PYD6070/1270 Owner’s Manual
MIC
Each mono input channel comes with an XLR
balanced microphone input connector and also
offers a +48V PHANTOM switch to supply power
for condenser microphones. Please mute the
playback/PA loudspeakers system before switching
on +48V PHANTOM power to prevent the switch-
on thumps being directed to the loudspeakers.
Please connect the microphones before switching
on the +48V PHANTOM power supply, do not
connect microphones to the mixer as long as the
phantom power supply is switched on. Wait for
approximately one minute to get the system
stabilized.
LINE
Each mono input channel comes with a balanced
1/4" (TRS) line level input jack. The unbalanced
devices can also be connected to this input.
NOTE
Please use only either the MIC or LINE input of
a channel at any one time, do not use both
simultaneously.
GAIN
This rotary GAIN control adjusts the channel input
gain level. Proper gain setting gives the mixer to
work in the best operating level. Please turn it
to 0 completely whenever you connect or
disconnect a signal source to one of the inputs.
EQ (HI/MID/LO)
ALL the mono input channels has a 3-band
equalizer, all bands provide up to 15dB of cut and
boost, with a centre detent for OFF. The cut-off
frequencies of HI and LO band are 10 kHz and 100
Hz respectively. The MID band is configured as a
peak filter with a center frequency at 1 kHz .
EFX
It enable you to feed channel signal to the external
effect.
PAN
It determines the amount of the channel signal
feeding the left and right mix bus, to locate the
source smoothly across the stereo image. Its
constant-power design ensure the signal is always
maintained at a constant level.
PEAK
It illuminates to warm you the input channel signal
is driven too high, which could cause distortion.
Use the GAIN control to adjust until the LED does
not light.
LEVEL
It determines the level of channel signal in the
MAIN mix bus and provides a clear visual indication
of channel level.
LO CUT (PYD1270)
It is a steep LO CUT filter designed to eliminate
unwanted low frequency hum. It is useful on live
vocals to reduce stage rumble or "popping" noise
from microphone.
CH1/CH2 For PYD6070 CH1/CH2/CH3/CH4 For PYD1270