Filter
Top Products
11
The Basics
5. Slowly slide up the channel volume control (CH) until you
get a reading of up to 0 dB on both LED meters.
6. Stop playback of the selected input source.
7. Repeat steps 1-7 for each audio input you plan to mix.
Notes:
• Write down the CH setting for each audio source. Then,
when you want to mix that source, you can adjust its
volume to that setting.
• If it was necessary to set CH 1 to maximum to get a
reading of 0 dB or less on the LED meter, slide CH 1 down to
about 8 and adjust MASTER upward until you get a reading
of 0 dB on both LED meters. If that does not work, set
GAIN midway and rotate MASTER clockwise until you get a
reading of 0 dB on the LED meters.
presetting microphone(s)
1. If your microphone has an ON/OFF control, turn it ON.
Otherwise, set DJ MIC LEVEL or AUX LEVEL to 0.
DJ MIC LEVEL AUX LEVEL