Filter
Top Products
16
Troubleshooting
LISTENING THROUGH
ANOTHER AUDIO
COMPONENT
If you connected an audio component (such
as a PA system) to your karaoke system, fol-
low these steps to listen to the karaoke sys-
tem’s sound through that component.
1. Press
STANDBY
to turn on the system.
STANDBY turns off.
2. Set
FUNCTION SELECTOR
to
AUX
. AUX
lights.
3. Turn on the audio component.
4. Play a cassette, CD, or CD+G in the
karaoke system.
5. Use the controls to adjust the sound. To
sing along with a CD or CD+G, see
“Singing with a CD/CD+G or Cassette
Tape” on Page 8.
6. To turn off the system, press
STANDBY
.
STANDBY lights and AUX turns off.
Then turn off the audio component.
ˆ
Troubleshooting
If you have problems operating your Hi-Power CD+G Karaoke System, use this chart to deter-
mine the problem and possible solutions. If you still have problems, contact your local
RadioShack store for assistance.
Problem Possible Cause Solution
The karaoke system does not
work.
No power. Make sure the power cord is
properly plugged into an AC
outlet.
Power is on standby. Make sure STANDBY is off.
A CD/CD+G is loaded, but the
CD/CD+G player does not
start.
The CD/CD+G is loaded
upside down.
Reload the CD/CD+G, label
side up.
The CD/CD+G is dirty or
defective.
Clean the CD/CD+G and
reload it, or try a different
CD/CD+G.
Moisture has condensed
on the pickup lens.
Unplug the system and wait
1 hour for the moisture to
evaporate.