Filter
Top Products
6
Connections
output jacks to
AUX IN R
and
AUX IN L
on the
karaoke system.
Note:
If your audio source does not have
AUX OUT R and L jacks, but has only a
headphone or line out jack (such as on a por-
table tape or CD player), use a shielded Y-
adapter cord with phono jacks on each end.
Connect the single-plug end to the audio
source’s headphone or line out jack, and
connect
AUX IN R
and
AUX IN L
on the
karaoke system.
Connecting an External Audio
Component for Output
You can broadcast the karaoke system’s
sound through an external audio component,
such as a PA system amplifier. Connect the
external audio component’s audio input jacks
to
AUX OUT R
and
AUX OUT L
on the karaoke
system.
Connecting an External Speaker
You can connect an external 25-watt external
speaker with 8-ohm impedance to the
karaoke system for a stereo effect. Plug the
speaker’s phono plug into
EXT. 8 OHM SPEAK-
ER RIGHT CHANNEL
on the karaoke system.
Connecting to a TV
You can connect your karaoke system to a
TV or monitor and see the words and images
produced by a special karaoke video cas-
sette or CD/CD+G. Plug one end of the sup-
plied cable into
VIDEO OUT
and the other end
into your TV’s VIDEO IN jack.
Note:
For TVs that do not have an audio/vid-
eo input jack, use a video RF modulator.
Connect the RF modulator to
VIDEO OUT
and
to the TV’s 75-ohm VHF input terminal, fol-
lowing the instructions in the modulator’s
owner’s manual.
CONNECTING POWER
When you have made all other connections,
plug your system’s power cord into a stan-
dard AC outlet. STANDBY lights.
Caution:
The supplied power cord has a po-
larized plug that fits into the outlet only one
way. If the plug does not fit properly, turn it
over and try again. Do not force it.
INSTALLING THE REMOTE
CONTROL’S BATTERIES
Your karaoke system’s remote control re-
quires two AAA batteries (not supplied) for
power. For the best performance and longest
life, we recommend RadioShack alkaline
batteries.
Cautions:
• Use only fresh batteries of the required
size and recommended type.
• Do not mix old and new batteries or dif-
ferent types of batteries (standard, alka-
line, or rechargeable), or rechargeable
batteries of different capacities.
Follow these steps to install batteries.
1. Slide the battery compartment cover in
the direction of the arrow to remove it.
2. Place the batteries in the compartment
as indicated by the polarity symbols (+
and –) marked inside.
3. Replace the cover.
You can use the remote control from up to 23
feet (7 meters) away from the karaoke sys-
tem. When the remote control stops operat-
ing properly, replace the batteries.
Warning:
Dispose of old batteries promptly
and properly. Do not burn or bury them.
Caution:
If you do not plan to use the remote
control for a month or more, remove the bat-
teries. Batteries can leak chemicals that can
destroy electronic parts.