20
Executive Single Channel system broadcast/receive
power.
Pairing the Microphone to the Charger Base
“Pairing” creates an encrypted association between
the Wireless Microphone and the Charger Base with a
unique electronic serial number. When the
Microphone and Charger Base have been previously
paired, the Microphone will automatically try to
connect to the Charger Base whenever it is lifted from
the Charger Base.
Note: The Microphone in new systems will need to be
manually “paired” prior to first use.
If a Microphone is lifted from the Charger Base and
the Microphone LED slowly flashes alternating
RED
and
GREEN
for 10 seconds, it means that the
Microphone needs to be paired to the system.
To pair the Microphone to the Charger Base:
1. Make sure the Microphone is turned OFF (no LED
activity). If the unit is ON, press and hold the
MUTE button for 10 seconds until the LED turns
solid
RED
then release. Alternately, place the
Microphone in the Charger Base for less than 2
seconds.
2. Enable the pairing mode by holding the
Microphone’s Mute button down for eight seconds.
The LED will turn solid GREEN and then solid
RED. Release the Mute button. The Microphone
unit is now in pairing mode.
3.
Push and hold the Charger Base’s Mute button for
eight seconds to enter into pairing mode then
release.
4.
The LED will be solid RED until pairing is
complete, as indicated by double flashing RED on
both the Microphone and the Charger Base (paired
and muted audio). If pairing fails at the end of one
minute on either unit, the LED will flash
21
alternately GREEN and RED for a few seconds and
turn OFF. If this happens, repeat these steps.