Filter
Top Products
12
Revolabs Solo™ Wireless Microphone
Revolabs Solo™ Wireless MicrophoneRevolabs Solo™ Wireless Microphone
Revolabs Solo™ Wireless Microphones
ss
s
Using with Wearable Wireless Microphone
The wireless personal microphone uses encrypted
communication to synchronize with the Charger
Base. It provides high quality full duplex audio
between the user and the computer, audio or video
conference system or external audio system. The
system allows the wearer to step out of the office or
conference room and still participate in the call.
1. Microphone port — direct toward mouth for best audio pickup.
2. Noise cancelling port — do not block opening.
3. Mute Button — press to mute, un-mute and pair microphone.
4. Pocket clip — also used to attach microphone to lanyard.
5. LED display — visual status for mute, un-mute, and pairing.
6. Earpiece jack — accepts the 2.5mm plug for the earpiece.
7. Charging port — docks to Solo Charger Bases.
Note: Microphones in new systems must be paired
to the Charger Base. See microphone pairing
instructions on page18.
Revolabs Solo™ Wearable Microphones turn on and
mute automatically when removed from Charger
Base, to reduce noise while being attached. The
microphone has a clip on the back which allows the
microphone to be easily attached onto a shirt pocket,
blouse, lapel or lanyard.
To use the Wearable Microphone:
13
1. Remove the microphone from the Charger Base.
The double-flashing RED LED on the Microphone
and Charger Base confirm that the mic is paired
and muted.
2. Attach the microphone to clothing or to a lanyard
close to the mouth, within 6-12 inches (15–30cm)
is recommended. Make sure microphone is
attached securely with the microphone port
pointed up toward mouth.
3. With the microphone in the wearing position, un-
mute the microphone by pressing and releasing
the Mute button (confirm by viewing flashing
GREEN LED). If the volume is too low, move the
microphone closer to the mouth.
4. To turn microphone off, return the Microphone to
the Charger Base. The Microphone LED will show
a 5 second self-test pattern and begin charging
(solid RED or GREEN LED). Alternately, turn off
the Microphone manually by pressing and holding
the Mute button for 10 seconds, until the LED
turns solid RED, then release the mute button and
the LED will turn OFF.
If the microphone is moved out of range of the
Charger Base (~65 feet or 20m) the connection will be
dropped (LED flashes all colors) and the microphone
will mute.
After 15 seconds the microphone will beep 5 times,
and will continue beeping every 30 seconds to remind
the user to return the microphone to the conference
room. If the microphone is moved back into range
within 15 minutes the connection will automatically
be re-established to its original state, and the beeping
will cease. If not, the microphone will turn off.
Adjusting the Volume
Adjusting the VolumeAdjusting the Volume
Adjusting the Volume on
on on
on the Wearable Microphone Earpiece
the Wearable Microphone Earpiecethe Wearable Microphone Earpiece
the Wearable Microphone Earpiece
To change the volume on the Wearable microphone
earpiece, use the dial on the earpiece wire.