Filter
Top Products
9
Português Italiano DeutschNederlands Español Français
English
Jack Panel
DC IN (AC Adaptor)
Jack
Connect the included AC
adaptor here (p. 4).
You must use only the AC
adaptor that is supplied
with the AC-33.
FOOT SW (Foot Switch) Jack
If foot switches are connected, you’ll be able to control the Looper function or turn e ects on/o using your foot.
You’ll need momentary-type foot switches (BOSS FS-5U or FS-6; sold separately) and a connection cables (Roland PCS-31 or PCS-33;
sold separately).
Set the polarity switch of the foot switches as shown in the illustration.
Polarity switch
Set the switches as follows
B A
BOSS FS-6BOSS FS-5U
PCS-31
White
(TIP)
Red
(RING)
BOSS FS-5U
PCS-33
BOSS FS-6
10
11
Security Slot ( )
http://www.kensington.com/
AUX IN Jack/[LEVEL] knob
R
L
Here you can connect a CD player or portable audio
player.
Use the [LEVEL] knob to adjust the volume.
The e ect is not applied to AUX IN jack.
LINE OUT Jacks
LR
You can connect your mixer or
recorder here. Connect to the L/MONO
jack if you’re outputting in mono.
The [MASTER] knob does not a ect the
output from the LINE OUT jacks.
12
14
13
11
11
11
11
11
10 11 12 13
14
NOTE
When connection cables with resistors are used, the volume level of equipment connected to the inputs (GUITAR CHANNEL, MIC/LINE CHANNEL, AUX
IN,) may be low. If this happens, use connection cables that do not contain resistors.
NOTE
You may connect to both types of AUX IN jacks simultaneously, but this may cause the volume to be lower compared to using one type exclusively.